Do you know how to replace brake shoes?

Update time:2022-08-18

1. Before replacing the brake pads, you should open the lid of the brake fluid reservoir in the engine compartment and check the height of the brake fluid page. If the brake fluid page is above the maximum limit, you should suck out some brake fluid to prevent Brake fluid overflows during replacement;

2. Prepare the brake pad to be replaced, and remove the wheel where the brake is located. Avoid scratching the rim during dismantling;

3. Use a wrench combined with the sleeve to remove the bolt of the brake caliper, and then remove the brake pad (if there is a brake sensor line, remove the brake sensor line first). Observe whether the brake pads are excessively worn or cracked, and if so, replace them in the next step;

4. Since the brake caliper will have a lot of sand or mud, it should be cleaned with a rag, and then applied with silencer paste to prevent abnormal noise when braking;

5. Use the piston pressure pump to press the piston to the position where it cannot be pressed, then install the brake pad on the brake caliper. After installing the new brake pad in place (the brake sensor line should also be installed), tighten the guide bolts, installed;

6. After the installation is complete, cover the lid of the reservoir tank, step on the brake pedal hard a few times in the car, and reset the brake. Then observe the brake fluid height, it should be within the appropriate height range;

7. After the replacement, conduct a test drive to check whether the braking effect is reflected.